Setup (Programming TV Control)
The Contour remote control is preprogrammed
to control your set-top box
but it must be manually programmed in
order to control the TV power and volume.
Follow the instructions below to program
your remote for your TV.
- Turn on the TV.
- Press the TV key on the remote.
- Press and hold SETUP until the TV key
blinks twice, then release.
- Enter the first five-digit code for the
TV brand that you wish to program found in the lookup below.
The LED blinks once as each digit is
entered. If the code is valid, the LED
blinks twice.
NOTE: If the LED does not blink twice,
repeat steps 2 to 4 and try entering the
code again.
- Aim the remote at the TV and press MUTE. The TV volume should mute.
If it does not, repeat steps 3–5, trying
each code for your brand until you
find one that works. If you cannot
find a code that works, see
“Searching for Your Code”.
Code Lookup
|
