Programming ID Lock
The Cox Universal Remote Control is preprogrammed and locked at the factory to operate the cable converter and interactive service given to you by your cable company.
However, if you have another brand or model of cable converter and interactive service that you would like to control, then you'll need to perform the following steps to unlock the cable ID lock, enter in a new manufacturer's code, and lock the ID Lock again.
- Turn on the Cable Converter.
- On the remote control, press CABLE once. Then press and hold SETUP until the CABLE key blinks twice, then release SETUP
- Enter 9-8-2. The CABLE key will blink four times.
- Perform the instructions in Programming Device Control in the SETUP section to program device control for the desired cable converter and interactive service. Upon completion, perform the remaining steps (5 and 6 on this page) to again lock the ID lock.
- On the remote control, press CABLE once. Then press and hold SETUP until the CABLE key blinks twice, then release SETUP.
- Enter 9-8-2. The CABLE key will blink twice.
|
