REMOTE SUPPORT by
HOME | | | |

Related Links



Setup

The Cox Universal Remote Control is preprogrammed to operate your cable converter, an RCA TV, an RCA VCR and a Pioneer audio receiver. To control devices other than the default brands, perform the following steps; otherwise skip this section:

Notes: To control a DVD player, program the VCR or AUX key. To control a PVR, program the VCR key. To control a stereo amplifier or receiver, program the AUX key. For TV/VCR Combo control, skip this section and perform the instructions on the next section.

If you have another brand of cable converter and interactive service you would like to control, you'll first need to unlock the cable ID Lock before changing the converter code - see Programming ID Lock section.

  1. Turn on a device and, if applicable, insert video media, (e.g., cassette or disc).

    Note: Please read steps 2-4 completely before proceeding. Write down the codes and devices you wish to program before moving on to step 2.
  2. On the remote control, press a device key once (e.g., AUX, VCR, TV or CABLE). Press and hold SETUP unti lthe selected mode key blinks twice, then release SETUP.
  3. Using the Manudacturer's Codes (starting below) to locate the type of device and brand name and then enter the first four-digit code for your device. If performed correctly, the selected mode key will blink twice.

    Note: If the selected mode key emits a long blink, the code is invalid. Repeat steps 2 through 3 and try entering the same code again.
  4. Aim the remote control at the device and press POWER once. The device should turn off. If it does not, repeat steps 2-3, trying each code for your brand until you find one that works. If it still does not work, try searching for the code.
  5. Repeat steps 1-4 for each device you want the remote control to control. For future reference, write down each working device code.

 


4 Digit Brand Code

Audio Amplifiers
Cable
Audio Amps/Tuners
TV
VCR
DVD