SETUP
The Charter 1060BC1 Remote Controls are
preprogrammed to operate the cable box (converter)
provided by your cable system, an RCA TV, a Toshiba
DVD player, and a Pioneer audio receiver. To control
devices other than the default brands, perform the
following steps; otherwise skip this section.
NOTE: If you have another brand of cable converter
or a satellite receiver you would like to control,
you’ll need to unlock the cable ID Lock before
changing the converter code.
- Turn on a device and, if applicable, insert video media, (e.g., cassette or disc) Note: Please read steps 2 through 4 completely before proceeding. Highlight or write down the codes and device you wish to program before moving on to step 2.
- On the remote control, press a device key once (i.e., AUX, DVD, TV, DBL, or STB); it blinks once. Then press and hold SET UP until the selected mode key blinks twice.
- Use the "Manufactuere's Codes" (on manual) to locate the type of device and brand name and then enter the first five-digit code for your device. If performed correctly, the selected mode key blinks twice. Note: If the selected mode key emits a long blink, the entry is invalid. Repeat steps 2 through 3 and try entering the same code again.
- Aim the remote control at the device and press PWR once. The device should turn off. If it does not, repeat steps 2 through 3, trying each code for your brand until you find one that works. If it still does not respond, try searching for the code. Note: If the device does not have a PWR key, press the Play key.
- Repeat steps 1 through 4 for each device you want the remote control to operate.
|
