Setup

The Cox Universal Remote Control is preprogrammed to operate your cable converter, an RCA TV, an RCA VCR and a Pioneer audio receiver. To control devices other than the default brands, perform the following steps; otherwise skip this section:

If you have another brand of cable converter and interactive service you would like to control, you'll first need to unlock the cable ID Lock before changing the converter code - see Programming ID Lock section.

1. Turn on a device and, if applicable, insert video media, (e.g., cassette or disc).
   Note: Please read steps 2-4 completely before proceeding. Write down the codes and devices you wish to program before moving on to step 2.



2. On the remote control, press a device key once (e.g., AUX, VCR, TV or CABLE). Press and hold SETUP until the selected mode key blinks twice, then release SETUP.
   
   
3. ENTER the five digit code for your device found in the lookup below. If performed correctly, the selected mode key will blink twice.
   Note: If the selected mode key emits a long blink, the code is invalid. Repeat steps 2 through 3 and try entering the same code again.
   
   
4. Aim the remote control at the device and press POWER once. The device should turn off. If it does not, repeat steps 2-3, trying each code for your brand until you find one that works. If it still does not work, try searching for the code.
   
   
5. Repeat steps 1-4 for each device you want the remote control to control. For future reference, write down each working device code.