BASIC SETUP: PROGRAMMING DEVICE CONTROL

The Titan universal remote control comes pre-programmed to operate the set-top box that is supplied by your service provider. In addition, Titan can be programmed to control four (4) additional home theater equipment devices.

NOTE: If you have another brand of set-top box that you wish to control with the STB key, you'll need to refer to “Re-Programming Set-Top Box Control”.

1. Turn on all of the devices that you wish to control.
   
   
2. On the remote control, press the mode key that you wish to program once (AUX, DVD, AUD,or TV, ); it blinks once.
   
3. Press and hold SETUP until the mode LED blinks twice.
   
   
4. Search for the “Manufacturer’s Codes” in the lookup below for the device you wish to control. Enter the first five-digit code for your device. If performed correctly, the mode LED blinks twice.
   
   NOTE: If the selected mode LED emits a long blink, the entry is invalid. Repeat steps 2 through 4 and try entering the same code again.
   
   
5. Aim the remote control at the device and press POWER once. The device should turn off. If it does not, repeat steps 2 through 3, trying each code for your brand until you find one that works. If it still does not respond, try searching for the code (“Searching for Your Code”).
   
   NOTE: If the device does not have a POWER key, press the (Play) key.
   Repeat steps 2 through 5 for another mode and/or key or press and hold SETUP to exit programming. TV Code
   

Please use manual for device code selection