OFA Simple 1 URC6410

Before resetting the Simple remote, please take the following into account:
If you have ever sent in your remote control to our Upgrade Service for an update, these codes will be erased as well. In that case, it is highly advised not to perform a factory reset.

To reset your remote to the manufacturer's setting please use the following procedure:

• Hold the RED + BLUE keys down until the LED blinks once and then twice.
• Enter code 981, the LED will blink four times.
• You can now setup your remote again.

If you would like to delete a learned function that you no longer require, please follow the procedure outlined below:

• Press and hold the COPY key until the light blinks twice.
• Press the function key on the One For All that you wish to delete the learned function from.
• Press and hold the COPY key until the light blinks twice.

Additional Information:
You can delete a learned key by overwriting it with a new learned function. If a learned function used in a macro is subsequently deleted, the macro will revert to sending the keys original function.

A long blink indicates that the remote failed to learn the signal from the original remote.

There could be a number of reasons for this. Check the following:

• Make sure the original remote that came with the device is in working order, by testing it on your device. If it is not responding, it might not be working correctly.
• Make sure you are not performing the learning procedure under bright lighting or in bright sunlight as this can interfere.
• Ensure that the two remotes are approximately 2 to 3 cm apart, and that the transmitting end of the original remote is facing the remote.
• Sometimes holding the key on the original remote down for slightly longer may help, and conversely sometimes quickly pressing and releasing the key on the original works better.
• The batteries used should have sufficient power. Even though the remote works when using it to switch on and off devices, it might not have enough power to be able to learn additional functions. Please replace a new set of batteries
• It is also possible that the memory on your remote control has reached the maximum capacity due to too many learned or other customized functions. Please remove some existing learned keys.
• Some manufacturer’s remotes use a different signal, or infra-red protocol, that the One For All remote cannot reproduce. These are commonly signals that use a higher frequency. Radio frequency remotes cannot be learned from, because these signals are not infra-red based.

Our remote controls always send out the standard duration of a signal, which enables most Macros. In your case, you need to keep the key pressed for a few seconds, which we are unable to reproduce into our Macros. Unfortunately, there is no solution for this. Our apologies for any inconvenience this may cause.

Please check the following web page which will lead you to support in your area: https://www.oneforall.com/support/universal-remotes